CENTURIA sheet

Telo traspirante impermeabile CENTURIA Cod. ACT-TTCEN

The Centuria sheeting between the boarding and the concrete is always recommended, to prevent the wood from absorbing water from the wet concrete mix. The waterproof sheeting also instantly prevents mortar from dripping through the joints, and the formation of dust in the underlying floors in the long run. Standard nylon sheeting is normally used in working sites. However, this has the disadvantage of creating a barrier at the level of the wood boarding, which can cause the formation and stagnation of humidity, with decay of the wood section of the floor. The use of materials specifically conceived for these applications is therefore highly recommended.

More information
Description
  • Material: 3-layer polypropylene
  • Weight: 150 g m2
  • Roll width: 1.5m
  • Roll length: 50m
  • Roll weight: 11.25Kg
  • Colour: light blue top / grey bottom
  • Steam permeability: approx. 2000 g/m2 /24H at 38° C
  • Resistance to steam Sd: 0.02 m
  • Temperature of use: -40° C/+80° C
  • Resistance to longitudinal tear: MD 300 N/5 cm
  • Resistance to longitudinal tear: CD 215 N/5 cm
  • Reaction to fire: E
  • Stability: UV 4 months

After laying two layers with overlapping sides, remove the adhesive film from the sheets and press the overlapping surfaces to join them together. It is also recommended to use additional double sided tape, to ensure good adhesion of the sheet to the underlying wood at the joints between boarding panels, where there might be small level differences. In case of holes in the boarding, once the holes have been drilled using the Ø 65 mm drill bit, remove all traces of chips and dust and apply the Ø 135/65 mm double sided adhesive reinforcement ring supplied. Once the paper film is removed (exposing the double sided adhesive) position the sheeting and cut out a disc as shown in the picture. This careful procedure allows to obtain the best seal for the connector and concrete slab support surface, avoiding water infiltrations underneath. Any damage or laceration must be repaired using sheeting off-cuts and double sided tape. For correct centering of the underneath beams, if the connector must be installed directly above the sheeting, before the same is applied, it is recommended to slightly pull out the heads of some nails used for securing the boarding at distances of approximately one metre, using a large flat screwdriver. Once the sheeting has been fitted, it will be easy to identify the position of the beams thanks to the small protrusions.
The waterproof breathable sheeting must be unrolled directly on the floor (or ceiling) surface, before installing the connectors (light blue side facing up, and grey side facing down). The edge of the sheeting that must be covered by the next sheeting is marked (10+10 cm).

SPECIFICATIONS

SPECIFICATIONS

Centuria waterproof breathable sheeting with adhesive edge, consisting of 3 polypropylene layers, weight 150 g/m2, with approximate steam permeability 2000 gr/m2 /24H at 38° C, steam resistance Sd 0.02 m, reaction to fire E, CE marking according to EN 19859 -1/EN 13859-2

Installation